Preces kods: 24582
PrimaCreator Value UV / DLP Resin – 1000 ml – Chromatic Silver
Ir Rīgas noliktavā.
|Noliktava||Ir Rīgas noliktavā.|
|Modelis||Value UV / DLP Resin|
|Materiāla tips||UV resin|
|Gaismas viļņu diapazons [nm]||395 – 405|
|Blīvums [g/cm3]||1.05 – 1.13|
|Cietība||85-88 Shore D|
When you want astonishing results for less cost than many other brands – PrimaCreator VALUE resin should be your first choice!
Resin from our VALUE line is a high-quality resin made from the best materials.
Your prints cures in sunlight or a UV curing chamber. When the curing is finished, the result is a rock-hard print with very small shrinkage.
The finished print is a solid colour part with a beautiful semi matte surface with excellent details and smooth layer transitions.
If you go for the transparent resin you will have a crystal-clear transparency which is truly stunning.
VALUE resin has many benefits over other brands of comparable resins.
The most noticeable is that it doesn´t smell very much.
VALUE resin is developed to perform well on low powered DLP machines such as the Creality LD, Wanhao Duplicator , SparkMaker, Anycubic Photon, Zortrax Inkspire and other printers that uses UV light for curing.
Optimized for UV Lightsource 395 – 405 nm.
Fast curing time, 4 – 8 seconds per layer for quicker prints.
After printing clean you print in IPA (Isopropyl Alcohol) to rinse of extra resin left.
When it´s time for curing you can use sunlight or a uv curing chamber.
Depending on print the curing times can vary:
In a UV light curing chamber, it will take about 2-5 minutes.
In sunlight, 10-20 minutes.
In daylight on a cloudy day it can take up to 60 minutes.
|UV Lightsource Wavelength:||395 – 405 nm (optimal)|
|Viscosity:||100-150 (25℃ m.pa.s)|
|Density:||1.05 – 1.13g/cm³|
|Hardness||85-88 Shore D|
|Tensile strength:||42.0 Mpa|
|Flexural Strength:||60 Mpa|
|Elongation at break:||10%|
|Storage temperature||5 – 40℃|